Макетиране и техники на макетирането | All about layouts > Похвалете се с вашия макет | Show us Your layout
Prognosis H0 model railroad - "The town from the dining room"
prognosis:
Gata si filmuletul cu rularea acestui vehicul pe diorama de la Slobozia
http://trenulete.info/renault-traffic-ho-pe-%C8%99ine-%E2%80%93-partea-a-treia/
prognosis:
More knowledgeable I have pointed out that hospitals do not really fit wheels with my trolley post modern allure. Therefore we changed using 9 mm diameter wheel dressing, wagon wheels Mehano. May to give a touch of authenticity, I painted the wheels red and white, befitting a genuine Romanian rail vehicle!
http://trenulete.info/renault-traffic-ho-pe-%C8%99ine-%E2%80%93-partea-a-treia/
Vlado:
:good: :)
prognosis:
Roco BR 93 steam locomotive - improvements
Presentation locomotive
How was natural, beautiful locomotive entered PanArin workshops for improvement. The original board was support for electrical modifications to the lighting. Cabin space allows digitization locomotive even though the plate is equipped with jack decoder, it can be easily changed. For starters I slowed substantially cart using pieces of lead runner printing that we put sum cart, around the axle, the weight obtained by testing until the car ran perfectly in all conditions of the diorama without having to make trouble. Basically it added about 15 grams of lead, which changed the original ride.
For lighting we used the technique of combining a white LED red-hot with a soldering SMD LED feet directly behind it in antiparalel. Excellent red light propagates through the body in this transfomand LED bicolor bipolar LEDs. Original plate, I replaced the ignition diodes that gave meaning to the original bulb with 980 ohm resistors, without making other changes. The same model we have used LED lights and rear.
prognosis:
Steam Locomotive BR 64 Gutzold - improvements
http://trenulete.info/locomotiva-cu-abur-br-64-gutzold-imbunatatiri/
The locomotive is the oldest generation, but kept in the cabinet for years. Does the factory only with light bulbs in front lights, rear lamps are visible. Metal rods are the engine of the old guard, with discoid collector is technically exceeded, noisy and stinking though is exaggerated for this locomotive speed when attacking a hill, under load, mentally and physically inferior. Although the locomotive weight is well proportioned, gives the engine, for which, the owner asked locomotive restoration and replacing them in circulation to nominal parameters soon to be digitized.
Enter PanArin workshops, the car was immediately disassembled and engineers have found solutions to change them.
He was elected an 12-volt motor, a copier from Sharp, engine type that has been placed on other trains refurbished to Shed PanArin and which gave surprisingly good results. His speed is a proper super steam locomotives, the rotor rather than the inertial torque with a weight has increased over the Chinese engine, acting as if they have a flywheel.
It was decided that replacing the motherboard textolit coils were placed shock and nutritional engine blades to collect accurate and the blood of the three axles motoare.Am circuit board used to design and achieve a new motor and caring support adiacente.Prin tin, on a plate were Tufted stands for the new engine and the engine was a piece of tinned copper with metric threaded screw 2mm exact original engine set antic.Pe same nail plate have drawn the circuit wife power law would reconditionate.Placa new car parts will hold and engine power, will support and connect the blades to collect blood from the wheels and will hold electrinica point lighting and rear lights. At bottom, I planted two shock coils which are powered by electric motor. Also there I located and bridge rectifiers will supply both sections of headlamps, the front s8i rear. Point LEDs, red for the rear lamps are in series between them, the middle one being numbered 820 ohm resistor. Also on the bottom right position is found in collecting blood slides.
Sample of light before being electrically connected traction engine ...
Today, although the day off, the craftsmen decided to continue assembling workshops PanArin front lights, so earlier this week, tests on locomotive lines to enter the city from the living room and will then be sent to the owner for digitization.
will follow
Навигация
[0] Списък на темите
Премини на пълна версия