Lima Postal wagon Kol 105 114
http://trenulete.info/vagonul-postal-lima-105-114-kol/The last of 11 311 seal Wt Lima, Kol 105 114 postal wagon, was purchased with the last Wt described below. The car was tortured by the old owner was trying to install interior lighting, little by ear. To repair the damaged buddy, I had to completely unravel the wagon, an operation that proved quite complicated because it's quirky design. Transparent plastic for the windows is a piece for all end and side windows and is placed in all slots and decupaturile possible, which makes it hard to dismantle it, especially as it joins the floor had been glued to his anteposesorul prenadez the chassis. Disassembly is very easy if toothpicks are inserted between the windows on both sides of the truck, then into one end to push the door windows of cars and shoot everything outside .... After disassembly and cleaning, I painted the floor with aluminum bronze and I mounted inside various transport crates and parcels.
As shown, the roof was also damaged by direct bonding of diodes with a very strong adhesive, which I removed with great difficulty ...
Being in my last car washer, we decided to have the final light. We used a new LED, 2 mm beam of light, which I entered through the wall and the exterior lantern I made of black plastic body, 2.5 mm thick, the clip material from closing / sealing a pipeline IDE socket on the motherboard of a PC.
For lighting I used in place of the board, a piece of forex (comatex) 3 mm thick, which I planted rectifier bridge, three light emitting diodes, current limiting light LEDs in series with the ceiling, (which I polished the end to remove magnifying glass), which are mounted in parallel. On the same board I mounted a 1k resistor in series with the lamp light the final. The wiring is copper wire from the cable network through this process can declare me as the inventor of the braiding process circuit, the cables being passed over for their safety by crossing various holes up and down the wiring board ... a process much simpler and more practical for those who do not or have not mastered the possibilities for wrapping in acid circuits.
All assembly is mounted directly on the wagon, under the ceiling and light Fizeau two pieces of bond paper (to put prices on products). Links to boghie lity are made with thin and flexible wires, the collection plate described in Item 11 311 wagon Wt
For light to see and eyelash extension roof observatory, I have chosen to Fret the inside where the skylight was faction observer, and I glued directly on the glass windows related.
On the side I glued white paper lantern I drew red signal lamp bars final.
And so my cars lining Lima has acquired a deserved place on the diorama, especially as cars are very beautiful with various elements and parts, with many accessories to mount the bellows extended to track shock to the floor that step is the passage of a wagon to another. There are many accessories in the kit mounted under the car, stands stairs, steps diverse pipeline, battery compartment, air tanks etc..
Thanks Pete for purchasing cars!
And a tip for owners of cars asftel LIMA, unhappy with the way they run. Coaches tend to jump on the curved lines on the piece, in slopes. This is because:
1. the boghielor not too high a degree of freedom in the vertical plane. It is easy to solve by widening the hole axis pivot.
2. axles are too tight on the track. Scoatrea be solved by a wheel on its axis and cylindrical grinding cylinder so easy distance of the wheel axle to be reduced by about 0.5 mm.
