The heat wave this week, I worked a little on this imaginary car. However we managed to advance work on time so it only remains for the interior furnishings, including floor. I postponed this goal for a neighbor willing to wait to bring my plate 2 mm thick sheet, which will aggravate the wagons and furniture over which you work.
VAGON Trailer
For wagon wheels, I planted underneath a bridge that we redressed current diodes that I brought on board. I finally chose the lamp oldest torch positioned in the middle, as VT automotorul 135-056. I used an LED diode punctifoma of 1.8 mm diameter, positioned on a circuit board and numbered with a 980 ohm resistor placed in the slot below the floor. Identical to another seat on the opposite side I put another 820 ohm resistor that feeds three of the SMD LED ceiling mounted parallel to light immediately at the lowest current. Also under the floor, a seat left open and I put a capacitor 420 to FM light stability. Thus, light and red lamp light ceiling lamps are lit constantly and regardless of the direction of travel.
VAGON TRACTOR
On the wagon tracks made by two plates have in order to have lighting on both ends. For lights we used transparent plastic light round the rest of the windows of houses fitted for diorama. Frame lights and their shirt is made of termocontractil hose. Such prisms are glued worked on wagon chassis so that it is easily removed.
On the circuit board, I glued down the right prisms SMD LED warm white, mounted parallel to each post and each in series with a 980 ohm resistor placed in temples hidden under the floor above-mentioned departments who have sezizat potential and we used to hide strength.
Otherwise we proceed as in wagon wheels ...
Mai multe imagini si explicatii
http://trenulete.info/automotorul-ap-020-01-partea-a-patra/
