Chart no. Set of 20 drawings from STIPP, set the first time we presented the construction shed built since 2009.
Presented on A4 paper, the various pieces of this set are very easy to accomplish and results in much more expensive than a plastic box kitt. The process is relatively simple. I have complicated things a bit, adding the sheet of paper a more solid support, ie 1 mm thick pressboard cardboard to give an increased stability of the building. It can be done by two methods. Whether simply cutting and pasting parts of their sketch, only paper or print them on school bond, cardboard cut pressboard walls, installation of the house and then pasting the sticker. I used an intermediate approach, ie we cut pressboard walls, I cut out the design on paper and after assembling the walls, I stuck with paper prenadez model.
We started with clamps but under the roof support, as I said, stuck with the cardboard backing prenadez pressboard 1 mm thick and cut with the climb and then rip. As we proceeded with the roof plate, which I left to dry.
I went on the walls to the coal bunker, which is about 2 mm thick, used as the inner support pieces of corrugated cardboard perfume boxes (packaging), thick cardboard and proper that I pasted paper model prenadez. Bunker is a reproduction of a wooden model.
Camera magazine is executed as described above. Sure, you can cut the window as we made the draw to be mounted inside luminaa. Prodecat I did not want to fill out so that only an outdoor lighting pole, such as those made by my home and I will not put the light inside
This building presents a back wall, 3mm thick, like a protective wall and integral with the rear wall of the warehouse. We used to provide indoor (in paper), the same forex board thickness, polished to catch prenadezul, on which I glued and folded paper by the same process model as described in the introduction.
Platform to support the magazine, was made by gluing all paper model hard pressboard, which I mounted the box walls and rear wall with coal bunker, after which I added to strengthen the roof and clamps above.
As we proceeded with the pillar of support and diesel pump, but worked directly from the paper. I do not recommend the use of polyvinyl acetate because the paper absorbs moisture model and curls. I worked two such shops, one of the original paper, copied from a Xerox color (laser) on the school bond. This process is simpler for use prenadezului remove, but it requires attention to fixing any further niscare not allowed. prenadezul let you move but a few minutes adjusting the correct position paper printed decoration.
It follows that after drying and curing, to do the finishing touches to creoiane colored pens or paper where the combination is too obvious, adding exterior lights and a white LED lighting pole-warm, decorate with flowers or ivy and arba, aging and dirt here and there, in important respects.
It follows a simple but beautiful work for modelers unpretentious, it appears that no relief from joining hollow bricks, but quite pleasant to the viewer. A simple layout and easy to do, the time being about 2-3 hours of work.
The set of plans includes several buildings that you try to accomplish in coming days and I will present after completion. Who needs these models can contact me!
http://trenulete.info/cladirea-loktankstelle-de-la-stipp/